[maddogmick]

Hi All
How do you wire double slips and reversed points in dcc I am at my wits end trying to understand the concept I have trains running but not over the double slip and if I go onto a spur that has a point switched for the headshunt no movement.
So can someone point me in the right direction I am not stupid just confused.

Shunter59

 

[poliss]

Take a look at the diagram about 3/4 the way down Brian Lamberts Electrical page. http://www.brian-lambert.co.uk/Electrical....0Motor%20Wiring.

 

[Richard Johnson]

*** The slip....Insulated fishplates on every rail of the double slip and a pair of feeds at the "waist".

Where a headshunt exists then insulate both rails where the two points that form a crossover meet and add a pair of feeds to the headshunt itself.

regards

Richard

 

[maddogmick]

Hi Richard
Thank you I will try that tomorrow night.

Best Regards
Mick

QUOTE (Richard Johnson @ 31 Oct 2008, 02:44) <{POST_SNAPBACK}>*** The slip....Insulated fishplates on every rail of the double slip and a pair of feeds at the "waist".

Where a headshunt exists then insulate both rails where the two points that form a crossover meet and add a pair of feeds to the headshunt itself.

regards

Richard

 

[maddogmick]

Hi
Thank you very much printing it off now and then have a good old read
Best Regards
Mick
QUOTE (poliss @ 30 Oct 2008, 22:18) <{POST_SNAPBACK}>Take a look at the diagram about 3/4 the way down Brian Lamberts Electrical page. http://www.brian-lambert.co.uk/Electrical....0Motor%20Wiring.