Model Railway Forum banner

Peco elctro double slip

4310 Views 4 Replies 3 Participants Last post by  maddogmick
Hi All
How do you wire double slips and reversed points in dcc I am at my wits end trying to understand the concept I have trains running but not over the double slip and if I go onto a spur that has a point switched for the headshunt no movement.
So can someone point me in the right direction I am not stupid just confused.

1 - 3 of 5 Posts
Hi Richard
Thank you I will try that tomorrow night.

Best Regards

QUOTE (Richard Johnson @ 31 Oct 2008, 02:44) <{POST_SNAPBACK}>*** The slip....Insulated fishplates on every rail of the double slip and a pair of feeds at the "waist".

Where a headshunt exists then insulate both rails where the two points that form a crossover meet and add a pair of feeds to the headshunt itself.


See less See more
Thank you very much printing it off now and then have a good old read
Best Regards
QUOTE (poliss @ 30 Oct 2008, 22:18) <{POST_SNAPBACK}>Take a look at the diagram about 3/4 the way down Brian Lamberts Electrical page.
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.