Model Railway Forum banner
1 - 1 of 24 Posts

· Registered
882 Posts
Most set track has holes pre-drilled, you then rest the pin into the hole and give a good whack!

However flexitrack does not have these holes
You can use a 1mm drill to drill your own holes, or do what I do

Get a piece of card and insert the pin into the card
Position the pin onto the track and whack
Remove the pin, then remove it from the card
Replace a new pin into the track hole created and drive it in with another clean whack

Using the original pin, repeat the process
1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.