Peco SL-E393F and SL-E394F Crossings

8233 Views 7 Replies 5 Participants Last post by dwb, Nov 27, 2015

Phil Newman

Discussion Starter · Nov 25, 2015

Can anyone advise me please on wiring up the above Peco crossings, I have read up on this subject and it seems the easy way is to use a frog juicer? These are quite expensive and i will be having a lot of crossings on my new layout so i want to wire these up as cheaply as possible if i can. I am running DCC and N Gauge. Any advice would be greatly appreciated. The above crossings are electrofrog by the way.

Save

1 - 2 of 8 Posts

Phil Newman

Discussion Starter · #3 · Nov 26, 2015

Hi Graham, I thought there must be a solution! Your right these crossovers come with four wires already attached one on each of the frogs and one on each of the outer rails. What I need to know is how to wire them for DCC so I don't have polarity issues. Thanks for your response, and if you have the answer please let me know.
Best Regards
Phil

Save

1 - 2 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month