Model Railway Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
please help ,iwould like to use the turntable on a dcc layout,im going to move it manually for now. its the changes in the + _ as it goes round. will this cause short cicuirts please help
 

·
Registered
Joined
·
24 Posts
Hi, I have recently just fitted a peco turntable to my DCC layout and it works fine (however I only use 1 line in 1 line out). However you must make sure that when lined up with each track the correct wiring is done; you must check that each rail is of the same side as the turntable, like with DC. Hope this helps.
 

·
Premium Member
Joined
·
4,854 Posts
QUOTE (neilf @ 18 Feb 2008, 14:48) <{POST_SNAPBACK}>please help ,iwould like to use the turntable on a dcc layout,im going to move it manually for now. its the changes in the + _ as it goes round. will this cause short cicuirts please help

Hi Neilf,

I raised the same question a couple of weeks back. If you look in the N Gauge Forum you will see a thread on TURNTABLE CONTROL which you might find useful. The semi-circular contact rings automatically resolve any ploarity problems provided you position the gap correctly.

Regards,

Expat.
 
1 - 3 of 3 Posts
Top