Model Railway Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
Can anyone tell me what the measurments are below the baseboard (depth) of both Seep & Peco point motors with & without auxillary switches, because space is fairly tight on my setup. Forgot to mention but I don't think it makes a difference I use "N" gauge Peco Streamline code 55 Universal Fine.

Thanks
 

·
Registered
Joined
·
4,497 Posts
They are all around an inch (25mm) deep without the ancillary switches - I'm not certain how much extra they add to the Peco points. If you fit direct to the point with a large cutout in the baseboard, then part of the pointmotor is lost in the baseboard thickness, or if used under the baseboard with a small slot for the operating pin then the full depth of the motor (plus the mount for Peco ones) is needed - about another 0.25in/6mm.

Regards,
John Webb
 
1 - 2 of 2 Posts
Top