Joined
·
33 Posts
Does someone know how i can wire up a route indication board without the use of point motors and LP13s ,the problem i have is i cant get under the base board to fit accessory switches or to fit wire in the rod (which i use on another section of my layout).Im running DCC so dont think i can take the power from the track by wiring the point blades?
Cos i will be standing near this section of the layout i am happy to do the hand of god but would really like route indication as it makes it so much easier on the eyeto run a layout especially when scenery is in place, as i say i use wire in the rod on the other side of the layout which is connected to slide switches that are wired to a route indication board and has its own power supply.
Can any thing be done
Cos i will be standing near this section of the layout i am happy to do the hand of god but would really like route indication as it makes it so much easier on the eyeto run a layout especially when scenery is in place, as i say i use wire in the rod on the other side of the layout which is connected to slide switches that are wired to a route indication board and has its own power supply.
Can any thing be done
