Model Railway Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
204 Posts
I think you would have to cut the wall up into sections: divide the wall up into sections of two arches with a pillar on the end, and then cut off the bottom of each section, to the maximum amount of the extent that the pillars extend above that little ledge.

then cut out the long wall sections at the top, above that little ledge, and place them (or cut them) at an angle to transition from one pillar to the next.

not sure if that's totally clear, but that's the only way I can think to do it using the wall as it is built.

EDIT: or you could not angle the top part of the wall at all, just have each section step down to the next.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top