Model Railway Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
3,966 Posts
i think it was ICM that did a motor that was supposedly a direct replacement for the XO4. the trouble was getting the gearing right. when i tried one the motor was a wonderfull fir but then i had the problem of getting the gears meshing properly and then quatering the wheels.

I am not sure about using brushless DC motors on DCC? DCC after the chip is the same as PWM contorollers (pulse width modulation). i may just be hoing crackers but i have never tried it. has anyone tired DCC with a portescap.

Peter
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top