Model Railway Forum banner
1 - 5 of 24 Posts

· No Longer Active.
Joined
·
13,704 Posts
Hi Steve & welcome to MRF.

As John says check to make sure that there a enough lubricant (not too much though) & running in gently will pay dividends in smooth running & longer life.

Please don't be tempted to use 3 in 1 though !
 

· No Longer Active.
Joined
·
13,704 Posts
QUOTE (kingsnorton @ 17 Jul 2008, 22:39) <{POST_SNAPBACK}>Now this is scary stuff, I have a friend that lubricates his locos with a spray of WD40, he wants to run his locos on my layout but I am hesitant to go along with this as I shudder when I think what it may do to traction tyres, very sad but I tend to put him off.
Almost certainly it will make them hard, brittle & then useless.

I would also be careful & not run your stock on his layout - the stuff is bound to be gunked up everywhere.

WD40 will actually make things run very well for a short time - than it will creep everywhere (after all that's what it's designed to do) to where it's not wanted & dry up - you may just as well spray the loco's with diesel/turps.

Many outlets sell oil in a syringe type dispenser so you can get just a tiny drop where needed. Oils/greases for fishing reels is supposed to be good as they are fine lubricants designed to stay put. (Must get some to try).
 

· No Longer Active.
Joined
·
13,704 Posts
QUOTE (Expat @ 19 Jul 2008, 05:18) <{POST_SNAPBACK}>I hope you're not talking about the stuff Peco used to sell as Electrolube and then changed the name to Powerlube.
At least when we get a locomotive in need of attention it's clear if the horrid stuff has been used by the smell ! - that way we know we are in for a complete stripdown.

It's almost as bad as their track "cleaning" rubber !
 
1 - 5 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top