Model Railway Forum banner
1 - 1 of 15 Posts

· Registered
43 Posts
Discussion Starter · #1 ·

I was just experimenting with an N gauge Peco electrofrog points and Seep PM1 point motor.

Has anyone else successfully used this combination to use the auxiliary switch on the seep motor to change frog polarity?

With a throw of just under 3 mm, how reliable is the sliding contact underneath the seep? Seems like very careful lining up is in order, to say the least...


1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.