Model Railway Forum banner
1 - 2 of 2 Posts

· Premium Member
6,205 Posts
Discussion Starter · #1 ·
Hi All,

While laying track i had need to hold the flexitrack in place to create an S kink in it whilst the glue set, looking around for a small screw to hold it temporary i came across some servo screws thin 10mm long and with a washer on the head to apply gentle pressure holding the sleeper down.
Once the glue has dried remove and reuse them
the hole made in the trackbed is not noticable once covered with ballast later.
About £3.50 for 50 on ebay.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.