Model Railway Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Can anybody tell me a simple way of programminig routes with this particular unit please? As I find the jumping about with numbers in the manual confusing, as the operation doesn't always do what its supposed to.

i.e. page 8 (if familiar with the manual) gives you 2 boxes concerning throwing outputs and closing outputs. I understand up to a point but when it gets to 64 - output 4 & outputs 7 & 8 are all 64 value. When you select the same 64 its runs through all of those numbers again. How can this be correct? All the other outputs have differing values so its a bit strange that these 3 have the same.

I might be the dumbest person on earth but In really don't understand what they are getting at with this manual as it doesn't make sense in this respect.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.