Model Railway Forum banner
1 - 1 of 9 Posts

· Registered
1,222 Posts
QUOTE (zmil @ 18 Sep 2008, 11:00) <{POST_SNAPBACK}>The main draw back I have with the MultiMAUS is I cannot change CV1 for 3 out of 4 Loco's without resorting to the same
technique , of pressure or clipping the Track output wires directly to the contacts

Could be due to the track voltage being too high - try two rows of diodes wired in parallel in track feed with each row having opposite polarities to act as a volatge drop. Take a voltage reading off the blue and white wires - mine originally was well over 20v before I fitted the diodes to bring in down to around 14v. TCS decoders in particular are fussy with high voltages when it comes to programming them.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.