Model Railway Forum banner
1 - 1 of 7 Posts

· Registered
1,275 Posts
My new A3" The White Night" also made a slight clicking noise when I first ran it. Because these models are designed to traverse 15" radius curves there is a lot of slop in motion. I found that one of the connecting rods was just toucing the screw on the front driver. I teased the the slidbar out slightly and it went away.
So far it hasn't come back. I'm going to tighten up all the motion on these models by adding spacers to the main and connecting rods.

1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.