Model Railway Forum banner

Un-responsive decoders

1K views 2 replies 2 participants last post by  Simon 
#1 ·
I have a few decoders that have been fited to various locos but are failing to respond to throttle requests. They read back ok and re-set ok so i assume the chip is alive. It's just that when dialing in some speed steps the motor fails to run. I've tried them in more than one loco so ii know the motor is ok.

Any suggestions or is it just a duff chip that needs returning?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top