Model Railway Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
497 Posts
does this relate to your other post re. r8247 ?

you problem is that the hornby decoder pulls its power straight off the dcc bus and the peco points do like there power, 0.2-0.4 all you should need to throw a solnoid if you have enough current

imo 16/0.2 is just about right for the peco solenoid try and keep the wire runs as short as poss also soldering the wires direct rather than using the peco looms to avoid any other problems
 
1 - 1 of 1 Posts
Top