Model Railway Forum banner

Viessmann Commander problem...

2K views 3 replies 3 participants last post by  wiggy25 
#1 ·
Everything has been working fine with my new Commander, that is till I did the update on-line, since then I have not been able to use the control buttons down the right side of the touch screen, I also find I am in Automatic mode and cannot get out of it, and when designing my own layout on screen the square I touch is always two squares to the right of the one I want, this is only happening on the right side of the screen, the left side of the screen works fine, but trying to get help and support is proving extremely difficult.

CW..
 
See less See more
1
Discussion starter · #3 ·
QUOTE (miksterr @ 16 Sep 2008, 12:19) <{POST_SNAPBACK}>Hi there,

PLease try and do a screen calibration...i am sure there will be something in the manual to describe how to do it.

Mike.

Thanks Mike, you are probably correct, but the buttons I need to press to do this are approx 3 square to the right off the screen, and there's no way to get to them.
CW..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top