Model Railway Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I have just taken delivery of an NCE Powerpro, and now need to start converting my OO gauge Steam Locos.

I have quite a few to convert, so one of my drivers is cost.

Does anyone have any experience with the NCE D13SR, as I found 10 of these for £90?

Alternatively, should I look to a better spec like Lenz?

Thanks

Mark
 

·
Registered
Joined
·
208 Posts
I would suggest TCS M1 as these are a good quality decoder and do not cost the earth, I use T1's for O gauge and have had no problems with TCS decoders but have blown 3 golds in different locos straigh of the programming track.

regards

mike g
 

·
Registered
Joined
·
208 Posts
QUOTE (MarkyGWR @ 3 Feb 2008, 22:52) <{POST_SNAPBACK}>Mike,
Thanks, where do you get them from?

Regards

Mark
I get mine from Digitrains in lincolnshire, the address can be found in BRM towards the back.

mike g
 
1 - 4 of 4 Posts
Top