Model Railway Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hi Guys,
this is definately not my week! after the problem with my Grafar Duchess (resolved) and my Minitrix Flying Scotsman(resolved) I now have to replace the drive cog on my Grafar Crab! Can anyone help, do I simply pull the valvegear off the pins on the wheels and hten pull the wheels off the axle? or are they screw fitted someway? sorry to be such a pratt, but i'm learning if slowly.

Regards Mike
 

·
Premium Member
Joined
·
4,854 Posts
Hi Mike,

Personally I wouldn't bother. I had the same problem with a little GF 0-6-0 and I simply ordered a new set of wheels, pre-quartered and with a factory fitted drive cog from the GF web site spares page. Cost - a fiver.

They were despatched by post the same day.
 

·
Premium Member
Joined
·
6,201 Posts
Hi Mike
I would follow expat's advice and contact Bob Russell in the first instance as he has sorted your Duchess ....reminds me i need a cylinder block for my Duchess
 
1 - 3 of 3 Posts
Top