Model Railway Forum banner
1 - 2 of 2 Posts

·
Administrator
Joined
·
10,002 Posts
I created this set of drawings for wiring an asymmetric or tandem 3 way point.

Slope Font Parallel Circuit component Pattern


David
 

Attachments

·
Administrator
Joined
·
10,002 Posts
QUOTE I simply fed power from the toe end and let the turnout blade do the conducting of power. It worked fine for me, and saved me some fancy wiring in a difficult to reach spot on the layout. Not a high tech solution but it worked.
Can you remember if that was for a code 100 or code 75 point? Simply feeding the power in from the toe will not work on the asymmetric version (code 75). The code 100 is symmetric and no special treatment is required.

David
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top