Model Railway Forum banner
1 - 1 of 12 Posts

· Registered
90 Posts
Discussion Starter · #1 ·
Hi Peeps

I have a mate who will shortly be wiring his layout. It will be a small shed layout that will have a peco motorised turntable. He will be using DCC for points but manual control of the turntable via a simple switched DC motor.

I have advised him on wiring of the points and main trackwork for DCC but i'm not sure what needs to be done to wire the turntable.

I'd be most grateful if somebody could advise please.


1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.