[upnick]

Hi all,
Has anyone found a worm gear puller suitable for n gauge use, or know of a supplier of the same.
As any search for them and after several mails no luck.

Any help would be most appreciated.

upnick.

 

[John Webb]

A tool supplier for clock makers may be worth searching for. Clock makers have the same need to remove small gears from shafts of small clocks. Hope this is of help.

Regards,
John Webb

 

[Brian Considine]

I have had some success in the past by heating brass worms with a small heat gun - be careful though !

 

[upnick]

I had thought of a source of heat, or i'll have to find a source of armatures already with worm gears, i did see a source some years ago all i know is the catalogue for them came with the peco catalogue dont know if it was a parent company.

upnick.