Model Railway Forum banner
1 - 2 of 32 Posts

· Ian Wigglesworth
750 Posts
I use the Seep point motors with built in switch.

I prefer using the toggle switches, the switches are connected to the SMD82 decoder, these will allow the points to be changed through the DCC controller, (in my case the NCE PowerCab) or using the switches.

Best of both worlds then, as I will mount the switches on a mimic board with LED's connected to the accessory switch on the Seep point motors, gives a quick and easy visual guide to where everything is set to, plus easy changes as well.

If I choose to use the controller then I can also do that if I wish.

1 - 2 of 32 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.