Hi.
I hear a good deal about droppers.
I understand what they are for i.e to take power to the rails and not rely on just fishplates.
However, I have read several postings which indicate, one can't have enough (almost).
Please would contributors advise me where I should have them?
Would this include at the throat of a point after a length of rail?
If I have several lengths of rail and points on a section fed through a DPDT switch and I put droppers on each will they all have to go back through the switch?
Any advice would be appreciated.
Thanks,
Jeff
I hear a good deal about droppers.
I understand what they are for i.e to take power to the rails and not rely on just fishplates.
However, I have read several postings which indicate, one can't have enough (almost).
Please would contributors advise me where I should have them?
Would this include at the throat of a point after a length of rail?
If I have several lengths of rail and points on a section fed through a DPDT switch and I put droppers on each will they all have to go back through the switch?
Any advice would be appreciated.
Thanks,
Jeff